burks pumps
Language: Chinese English

Pump knowledge

What to Do About Odors from a Basement Sewage Lifting Unit? A Two-Path Troubleshooting by Timing

A sewage lifting unit installed in the basement was originally meant to solve drainage for bathrooms and laundry rooms below the main sewer. But after some time, odors started to appear, and they became more obvious when the door was closed. Don't rush to conclude that the equipment is broken. Most odors are not caused by the pump itself; rather, gas leaks from places where it shouldn't come out. The key to troubleshooting is to first observe when the odor appears, then check along two lines: the air path and the water path. This is much more complete than just replacing a gas valve or doing a single cleaning.

Step 1: Locate the source by timing. If the odor only appears during drainage, it is most likely poor ventilation: when the unit drains, pressure changes inside the tank force gas into the room. This is common when the vent pipe is blocked, not led outdoors, or the gas valve is aged and doesn't close tightly. If the odor is constant, even when no water is used, it is likely a sealing or trap issue: the tank cover gasket is aged, the inlet pipe connection is loose, or the water in the traps of floor drains and washbasins that are rarely used has dried up, allowing sewer gas to come directly through the pipes. If the odor worsens after water use and is accompanied by frequent starting or alarms, be alert to fouling and fermentation inside the tank, backflow from the check valve, or poor drainage. In this case, don't just try to remove the odor; stop using the unit and troubleshoot first.

burks sewage lifting pump

Step 2: Check the air path. Check whether the vent pipe is unobstructed, whether it is led to an outdoor high point as required by the installation instructions, and whether it has been sealed off by renovation or blocked by debris. If there was no independent ventilation condition originally, see whether the equipment is equipped with activated carbon filtration or a sealed gas valve. Such accessories have a service life and must be replaced according to the manual after they fail; do not leave them unchanged for a long time. There are roughly three ventilation solutions: if conditions allow leading a pipe outdoors, give priority to connecting the vent pipe and leading it outdoors; if there is no condition for leading it outdoors, use the activated carbon or gas valve solution provided with the equipment and keep track of the replacement cycle; for old house renovations with limited pipe routing, ask the installer to inspect the routing on site before deciding on a solution, and do not modify the pipes arbitrarily yourself.

Step 3: Check the water path. Run water into each floor drain, washbasin, and shower that is not frequently used to replenish the traps. This is a very common cause of odors after returning to a long-vacant home. After replenishing, observe for one or two days to see if the odor diminishes. Then check the exterior of the tank and all connections for signs of leakage, and check the floor for dampness or mold. Leakage at connections not only produces odor but also indicates that the seal is no longer reliable. If kitchen drainage is connected to the same unit, pay special attention to grease: grease entering the tank tends to cling to the walls and ferment, making the odor stronger. Do not pour large amounts of grease directly into the sink in daily life.

Step 4: Consider the type of equipment. For an integrated sealed lifting unit, focus on the tank cover seal, vent, and connections. The tank itself is sealed; do not open the cover to clean it yourself. Internal cleaning and gasket replacement should be handled by after-sales service. For a sump pit with a submersible pump, focus on whether the pit cover is tightly closed, whether the pit has long-term fouling, and whether ventilation is led out separately. Gaps in the pit cover are often the exit for odors. Do not apply the same solution to both types of equipment.

Safety red lines come first: if the odor is accompanied by alarms, frequent starting, slowed drainage, or water seepage on the floor, stop using the relevant fixtures and do not continue flushing. Do not open the sealed tank cover yourself; the gas and sewage inside are not ordinary dust, so take protective measures when handling. Any work involving pipe removal, vent pipe modification, seal replacement, or electrical parts should be handled by professionals or after-sales service. If there is smoke, electric leakage, or an odor accompanied by a burning smell, immediately cut off the power and stop using the unit, then contact professionals.

Daily prevention is actually not complicated: keep frequently used fixtures in normal use, and regularly replenish water at drainage points that are not used for a long time; do not flush wet wipes, debris, or large amounts of grease into the unit; replace ventilation filter accessories on schedule; and perform a simple annual check of external connections and alarm functions. By doing these few things, most odors can be traced to their source at an early stage and will not develop into odors throughout the entire basement.

If after the above two-path troubleshooting you still cannot locate the source, or if you need to confirm ventilation modification methods and accessory replacement cycles, you can contact us via the contact information on the website page or online customer service. Clearly state the equipment type, when the odor appears, and whether alarms occur, and we will help you determine the next step.

Related products: burks B-Lift55L sewage lifting unit pump station equipment; burks WC-3 QWC-3 series household sewage lifting unit toilet lifting device; burks B-Lift100L sewage lifting pump double pump station